Service areas / Redmond
We work Redmond regularly, roughly twenty minutes from our Bend shop, on both established neighborhoods and newer developments.
Painting in Redmond
Redmond sits lower and drier than Bend, and wind exposure is a bigger factor here than snow. Open lots without mature trees take direct sun on all four elevations, which shortens the life of a finish on every side rather than just the south wall.
The open ground north of Redmond, out toward Terrebonne, is the extreme version of this. We repainted a home there where the owners called us because the color had gone flat across every elevation rather than just the south wall, and the caulk joints had cracked open. With no tree cover there is nothing to break up the sun, so the whole envelope ages at the same rate. That one went back on as a three-tone, body, trim, and gables.
A duplex we repainted in Redmond showed the whole failure pattern at once. Both sides had faded past the point of chalking, where UV has broken down the binder holding the pigment together and the colour comes off on your hand as powder. Chalk is a bond breaker, which is why a repaint starts with a real pressure wash and not a rinse: paint applied over chalk has nothing solid to grip and fails early no matter what it cost. The caulk joints had let go as well, so we cut the old caulk out instead of caulking over it, spot-primed, used a high-build bonding primer to bridge the feathered edges where the old paint had peeled, sanded those areas flush so they would not telegraph, and put the building back as a two-tone in a single sheen.
A lot of Redmond housing stock is 1990s and 2000s construction with hardboard siding. That material needs the bottom edges checked carefully for swelling before anything gets coated.
Services
Residential only. Interior, exterior, cabinets, and exterior wood, for homes across Redmond and the surrounding area.
High-desert shield
Central Oregon exteriors take UV, snow, and wide temperature swings most coatings aren't built for. We use weather-resistant paints and full surface prep so the finish holds through the seasons, not just the first summer.
Get a quote
Precision finishes
Careful surface prep, clean lines, and low-VOC paints for living spaces, great rooms, and everything in between. We mask and protect every surface in the room before a wall gets touched.
Get a quote
Factory-smooth finish
A factory-smooth cabinet finish that updates a kitchen or bathroom without the cost of a remodel. Durable, high-end, and built to take daily use.
Get a quote
Built to last outside
Central Oregon's UV and winters are hard on exposed wood. Our staining process protects the wood's structure and keeps the natural grain visible, with real curb appeal for years, not one season.
Get a quoteEstimate
Planning range only. Your on-site quote reflects the real condition of your home.
A ballpark range in a few clicks.
sq ft of floor area
Clean walls with minor scuffs or nail holes. Minimal prep needed.
Quality paint for a clean, refreshed finish.
Estimates are for planning only. Your free on-site quote reflects the real scope of your home.
Common questions
That is chalking, and it is the most common failure we see on open lots around Redmond. UV breaks down the binder that holds the pigment in the paint film, and once the binder goes the pigment is left sitting loose on the surface. It matters more than it looks: chalk is a bond breaker, so fresh paint applied over it has nothing solid to grip and will fail early regardless of how good the coating is. The fix is not complicated, it is just not optional. The surface gets pressure washed until it stops shedding before any primer or paint goes near it.
Because the joint moves and the caulk has a limited amount of movement it can absorb. Central Oregon swings a long way between daytime and overnight temperatures, so siding and trim expand and contract every single day. Once that daily movement exceeds what the caulk can take, it splits, and the paint over the top splits in the same line. Caulking over a failed joint just hides it for a season. We cut the old caulk out and replace it.
No. Redmond is inside our standard service area and there is no travel surcharge.
Redmond pricing tracks close to Bend, generally $4,000 to $11,000 for an exterior repaint. Lot exposure matters here: homes on open lots with no wind or sun protection sometimes need a higher-grade coating.
Free estimate
Send a few details and we'll get back to you to schedule a free on-site walkthrough and a firm price.
Free written estimates for homeowners in Bend, Redmond, Sisters, Sunriver, and Powell Butte. Every project backed by a 2-year workmanship warranty.
Licensed & insured Central Oregon painting contractor. CCB #260698.